This 15 lbs/min Complete Portable Polymer Preparation System is designed to prepare up to 15 lbs/minute of active
polymer in a dry form. The system is installed in three (3) sea containers and is designed to make down polymer at
a 0.5% solution into five (5) mixing/aging tanks. The system contains four (4) feed pumps with variable frequency
drives. Two (2) pumps are designed for pumping 0.5% polymer solution up to 1,000 gpm at pressure up to 120 psi
and two (2) pumps are designed for pumping a 0.5% polymer solution at a variable range up to 200 gpm at pressure
up to 120 psi.
Location: State of New York, USA
Can be purchased “En-Bloc” with 150408-SE – 20,000 gallon Fiberglass Storage Tanks (used for Polymer)
Principal Dimensions and Characteristics | ||||
Major Components | ||||
Three (3) Sea Containers: | 12.19 x 3.05 x 3.05 m | 40 x 10 x 10 feet | ||
Two containers are stacked: the top container houses an electric chain hoist and storage space |
||||
Polymer screw feeder (located in the bottom container). Stainless shaft and propeller, Siemens 1 hp (0.75 kW), 460 V, 3 ph motor. 3003675233�41, Vacon drive 12004204. |
||||
Polymer make�up water pump (P33). Grundfos CR64�1�1, 10 hp (7 kW), 230/460 V, 3 ph. | ||||
Polymer water booster pump (P36). Gould’s 3656 pump 16BF1L5HO, 10 hp (7 kW), 230/460 V, 3 ph. | ||||
Two primary polymer feed pumps with VFD (P49, P50). Netzsch Nemo 105BY01L07V�000 with 40 hp (30 kW), 230/460 V, 3 ph Nord motors. |
||||
Two secondary polymer feed pumps with VFD (P29, P30). Netzsch Nemo 063BY01L07V�000 with |
||||
Spare Parts | ||||
|
||||
All details on these pages are given in good faith and are believed to be accurate but no warranty of accuracy or completeness or suitability for purpose is either stated or implied. Prices are subject to change without notice. |