20 inch Ellicott Dredge 1870

    Built in 2019 by Ellicott. The series 1870 Dragon cutterhead dredge is a medium to large size dredge that is portable and can be transported by truck. It has a max dredging depth of 50-ft (15 m). Total installed power not including standard Genset is 1,755 hp (1,309 k). Power at Cutter Shaft is 250 hp (186 kW). Cutter diameter is 54-in (1,372mm). Cutting force is 14,900 lbs (6,759 kg). This dredge has been exposed to sea water most of its life. It has been sitting dormant and not been used for over 8 months.

    Available 14,000-ft of 20-inch OD SDR-17 HDPE Pipe with floats & Pipe angles for an additional cost.

    Location: State of Virginia, USA

             
    Principal Dimensions and Characteristics
      Length Overall: 35.5 m 117-ft
      Length, Hull: 25 m 82-ft
      Width: 8.2 m 27-ft
      Depth, Hull: 1.8 m 6-ft
      Dry Weight: 186,000 kg 410,000 lbs
      Draft (not including spuds): 1.2 m 4-ft
      Swing Capacity @ min dredging depth: 46.3 m 152-ft
      Swing Capacity @ max dredging depth: 37.2 m 122-ft
    Engine
      Type: Caterpillar 3512
      Power: 955 kW 1,280 hp
      Fuel Capacity: 29,900 liters 7,900 gals
      Auxiliary Engine: Caterpillar C-15
      Power: 354 kW 475 hp
      Rating: Tier 3 Tier 3
    Cutter Drive
      Power at Cutter Shaft: 186 kW 250 hp
      Cutter Diameter: 1,327 mm 54-in
      Cutter Speed: 18-27-36 rpm  
      Cuttering Force: 6,759 kg 14,900 lbs
    Dredge
      Type:  
      Discharge Diameter: 500 mm 20-in
      Suction Diameter: 500 mm 20-in
      Dredging Depth: 15 m 50-ft
    Spuds
      Diameter: 610 mm 24-in
      Length: 20.4 m 67-ft
             
      All details on these pages are given in good faith and are believed to be accurate but no warranty of accuracy or completeness or suitability for purpose is either stated or implied. Prices are subject to change without notice.