20 inch Ellicott Dredge 1870

  • 3,077,000 USD
  • 221108-DB

Built in 2019 by Ellicott. The series 1870 Dragon cutterhead dredge is a medium to large size dredge that is portable and can be transported by truck. It has a max dredging depth of 50-ft (15 m). Total installed power not including standard Genset is 1,755 hp (1,309 k). Power at Cutter Shaft is 250 hp (186 kW). Cutter diameter is 54-in (1,372mm). Cutting force is 14,900 lbs (6,759 kg). This dredge has been exposed to sea water most of its life. It has been sitting dormant and not been used for over 8 months.

Available 14,000-ft of 20-inch OD SDR-17 HDPE Pipe with floats & Pipe angles for an additional cost.

Location: State of Virginia, USA

Principal Dimensions and Characteristics
  Length Overall: 35.5 m 117-ft
  Length, Hull: 25 m 82-ft
  Width: 8.2 m 27-ft
  Depth, Hull: 1.8 m 6-ft
  Dry Weight: 186,000 kg 410,000 lbs
  Draft (not including spuds): 1.2 m 4-ft
  Swing Capacity @ min dredging depth: 46.3 m 152-ft
  Swing Capacity @ max dredging depth: 37.2 m 122-ft
  Type: Caterpillar 3512
  Power: 955 kW 1,280 hp
  Fuel Capacity: 29,900 liters 7,900 gals
  Auxiliary Engine: Caterpillar C-15
  Power: 354 kW 475 hp
  Rating: Tier 3 Tier 3
Cutter Drive
  Power at Cutter Shaft: 186 kW 250 hp
  Cutter Diameter: 1,327 mm 54-in
  Cutter Speed: 18-27-36 rpm  
  Cuttering Force: 6,759 kg 14,900 lbs
  Discharge Diameter: 500 mm 20-in
  Suction Diameter: 500 mm 20-in
  Dredging Depth: 15 m 50-ft
  Diameter: 610 mm 24-in
  Length: 20.4 m 67-ft
  All details on these pages are given in good faith and are believed to be accurate but no warranty of accuracy or completeness or suitability for purpose is either stated or implied. Prices are subject to change without notice.