IMS Model 4010-LP – 10-inch Horizontal Dredge

  • 129,000 USD
  • 150513-DH

This IMS Model 4010-LP – 10-inch Horizontal Dredge was built in October, 1996. The Dredge was recently rebuilt in 2015 by CDW and it has new pontoons designed by CDW to fit existing footprint/frame. The entire hydraulic system was redone as well and the dredge was also painted. All functions operate. Engine assembly is original as there are only 5,461 hours on the unit and all testing indicated that the engine was in good condition. The Dredge has not been in the water since the rebuild. Dredge has had a sludge paddle bar installed and an excavation bar could be ordered from the factory.

Located in the State of Kansas, USA

 
Principal Dimensions and Characteristics
  Year Built: 1996
  Length Over All: 9.33 m 30.6 feet
  Width: 2.62 m 8.6 feet
  Height: 3.17 m 10.4 feet
  Operating Draft: 508 mm 20 inches
  Weight: 6,804 kg 15,000 lbs.
  Total Displacement: 9,299 kg 20,500 lbs.
  Working Depth: 6.10 m 20 feet
  Floats: (4) Pressure tested
Power Source
  Main Engine:
    Make/Model: Cummins turbo-charged after cooled industrial diesel
    Power @ 2,400 RPM: 130 kW 174 hp
    Usable Fuel Capacity: 662 liters 175 gallons
  Hydraulic Pump:
    Make/Model: Vickers (or equal)
    Discharge Diameter: 254 10 inches
  Hydraulic Oil Capacity: 246 liters 65 gallons
  Thermostatically controlled hydraulic oil cooler
  Variable speed control for accessory circuits
  10 Micron hydraulic oil filter
  Hydraulic system water removal filtration system
Performance
  Discharge Volume:
    Water: 0 – 17,034 liters/min 0 – 4,500 gallons/min
    Sludge: 0 – 11,356 liters/min 0 – 3,000 gallons/min
  Variable Travel Speed: 0 – 100 RPM
  Maximum TDH: 30.48 m 100 feet
   
  All details on these pages are given in good faith and are believed to be accurate but no warranty of accuracy or completeness or suitability for purpose is either stated or implied. Prices are subject to change without notice.