-
80-tonne Modular Jack Up Barge
18 m x 12 m dismountable jack up barge. Movable using 10 trucks (8 x 40-ft and 2 x 60-ft). Spuds are 18 m in length and wall thickness of 25 mm. The barge has a deck load of 15 t/m2 and a deck lifting capacity of 80 tonnes. Location: Ireland Principal Dimensions and Characteristics…
-
54-feet x 30-feet Truckable Barge with Crane and 400-hp Push Boat
Barge is truckable in four pieces. 3 sections are 40-ft x 10ft each and 1 section in stern that is 14-ft x 30-ft. The stern section includes the galley and tool room. The barge has 4 studs each with a length of 45-ft. Spuds are raised and lowered using the crane. The crane is a…
-
60-inch Pipe Lay Barge w/ DP and 1000-tonne Revolving Crane
Built in 1976 and fully rebuilt and upgraded in 2009. Capable of laying pipes up to 60″ in offshore waters. Deck area is 1500m2. The barge can accommodate up to 280 persons. The main crane is a Clyde DE52 230 + 30 + 15 with capacity up to 1000t (fixed) at a radius of 22m…
-
45m x 12m x 3 m Spud Deck Barge (Spud pontoon)
The deck barge was built in 1975 in the Netherlands. Spuds and equipment were built in 1988-89. The classification is Buerau Veritas (“Deep Sea”) but has been discontinued. There are 3 spuds each 14m in length that are rope driven. The barge length is 45m, width is 12 m and height is 3 m. Location:…
-
36-feet x 12.5-feet Work Spud Barges (2)
2 work barges. One is 36-inches in height and the other 42-inches. Both barges are 35-ft in length and 12.5-ft in width. Both barges also have 2 spuds. Both of these barges have recently been blasted, painted , redecked where necessary new manhole were renewed as required. Price is for each barge.Location: State of Texas,…
-
1,300 m3 Split Hopper Barge, Reinforced for Rock
Built in 2010, the barge hopper is 35mm thick and can be used for rock & stone. The main engine is 2 NINGDONG with 2 x 473 hp. Maximum speed is 11 knots. The barge length is 64.85 m, beam is 13.2 m and depth is 4.6 m. Location: Malaysia General Built: 2010 Class Society…
-
91 m, 7,400 DWT Deck Barge
Built in 2012 in China, it was used by the shipyard that built her for light shipyard work. The barge remains in very good condition and ready to be put in service.. Ramp door & hydraulic winch were installed in 2019. Barge is 91.5 m in length, 24.4 m in breadth and has a depth…
-
61.44 x 16.17 x 3.85 m Deck Barge DWT 2000
Max deck load of 12 T/m2. Barge has 10 ballast tanks and 2 ballast pumps and 6 ballast main pipe lines. Ballast tanks are hard coated. New build 2020 in Turkey and has a Class of RINA. The barge NT is 264T and GT of 882T. Location: East Mediterranean General Built Year / Place: 2020…
-
91.5 x 27.5 x 5.5 m DWT 8579
Heavy deck cargo barge has an area of 2503 m2 with a max. deck load of 8T/m2. Void tank area is 12,641 m3. The barge was built in 1994 in Singapore and has a class of NV-GL, +1A1 Barge, Ocean Going. Location: Greece General Built Year / Place: 1994…
-
28 m x 16.2 m x 3 m Heavy Spud Barge
This listing is for a 28 m x 16 m x 3 m Barge with 4-point Mooring. It was built in Lebanon in 1999 and was reconditioned there in 2019. Its’ Classification Society and Notation is IROS (International Register of Shipping). Barge is currently fitted with a 75 Ton Lima Crane and a manual grab…
-
330-Person Accommodations Barge
Built in 2009 in Korea, the barge flag is Marshall Island and Classification and Notation is ABS + A1 Barge. The barge is 100m (328-ft) in length and has a breadth of 30.50m (100-ft). Clear deck area is 1,335 m2. Lift equipment includes a 68 tons @ 6.8 m radius main hoist, a 11 tons…
-
31.2 m x 16.7 m x 2.4 m Jack-Up Barge
The Jack-Up barge has a deck load capacity of 570T – 3T/m2 and a maximum water depth of 28 m (92-ft). Spud lifting speed is 0.4 m/min. The barge was built in 1989 and has had several conversions since. Class Society and Notation is BV Self Elevating Coastal Waters. Location: Europe …
-
610-tonne Payload Jack-Up Barge for Charter
This 42 x 23.5 Jack-Up barge has available deck area of 800 m2 and a deck load of 10T/m2. The barge has 4 x 37.5 m spuds. Maximum elevated height is 26.6 m. The barge was built in 1999, it’s flag is St Vincent & The Grenadines. Class Society and Notation is BV I Hull…
-
150-tonne Self-Propelled Revolving Crane Barge
The floating crane can lift loads up to 150 mt, transport them on water and precisely position them. The crane is more flexible than mobile or port cranes in the handling of heavy and/or oversized cargo. Due to the floating cranes, waterside operations do not stain the quay. On the cranes’ cargo, loads can be stowed and transported over longer distances before safely being offloaded…
-
7905 DWT Ballastable Barge for Charter
Strengthened for Heavy Cargo. 70.3 m length x 32.16 m breadth and a depth of 7.00 m. Draft is 4.80 m. Ballast tanks have a capacity of 13.270 m3 and have 2 pumps each 1.200 m³/h / 50 Hz / 23mWS. Barge Class Society & Notation is GL100 A5 RSA (200) PONTOON. Location: North Europe…
-
400 m3 Self-Propelled Split Hopper Barge
Built in 1997 and completely renovated in 2019, and both engines were replaced by two new ones. The split hopper barge has a hold capacity of 400m3 (523 yd3). It is powered by 2 Diesel Volvo Penta engines with 630 hp. It has 2 Azimuthal Columns Aquamaster Rauma thrusters. The barge has a GT of…
-
96.7m x 19.8 m x 5.75m Self Propelled Deck Barge w/Ramp
Powered by 2 CUMMINS K50-M with 1342 kW (1825 hp) each has a max speed of 12.3 knots and a service speed of 11.8 knots. The barge has fixed pitch propulsion. GT is 2676 and dead weight is 5060 Ton. The barge was built in 2017 in China and its Port of Registry is Korea.…
-
1700 m3 Self-Propelled Split Hopper Barge
This barge has a class INSB with a navigation area of Trips Coastal, 20 NM of shore. The barge is 74.35 m (244.5-ft) in length, with a beam of 14.0 m (50-ft) and depth of 4.5 m (14.8-ft). Deadweight 3000T. The barge is powered by 2 X JINAN, G6190 with 540 kW @ 1450RPM. The…
